Sparta D-BURST M8TB Owner'S Handbook Manual Download Page 78

Page: 78 / 230

English –

Speedsensor (slim)

The speedsensor (slim)

(4)

and its magnet

(5)

must be

mounted in such a manner that the magnet, after a turn of
the wheel, moves past the speed sensor with a clearance of
at least 2 mm, yet no more than 8 mm.
If any structural changes are made, the correct distance
between the magnet and the sensor must be complied with
(see figure

Note:

Make sure you do not damage the sensor or the sensor

holder when fitting or removing the rear wheel.

Operation

Start-up

Requirements

The eBike system can only be activated when the following
requirements are met:
– A sufficiently charged battery is inserted (see battery op-

erating instructions).

– The on-board computer is properly inserted in the holder

(see on-board computer operating instructions).

– The speed sensor is correctly connected (see "Checking

the speed sensor (see figure A)", page English – 2).

Switching the eBike system on/off

The following options are available for

switching on

the

eBike system:
– If the on-board computer is already switched on when you

insert it into the holder, the eBike system will be activated
automatically.

– Once the on-board computer and the eBike battery are

fitted, briefly press the on/off button on the on-board
computer.

– With the on-board computer inserted, push the on/off

button on the eBike battery (bicycle manufacturer-spe-
cific solutions are possible when there is no access to the
battery on/off button; see the battery operating instruc-
tions).

The drive is activated as soon as you start pedalling (except
if you are using the push-assistance function, Switching the
push assistance on/off). The motor output depends on the
settings of the assistance level on the on-board computer.
As soon as you stop pedalling when in normal operation, or
as soon as you have reached a speed of

25/45

km/h

, the

eBike drive switches off the assistance. The drive is automat-
ically reactivated as soon you start pedalling again and the
speed is below

25/45

km/h

The following options are available for

switching off

the

eBike system:
– Press the on/off button of the on-board computer.
– Switch off the eBike battery using its on/off button (bi-

cycle manufacturer-specific solutions are possible when
there is no access to the battery on/off button; see the bi-
cycle manufacturer operating instructions).

– Remove the on-board computer from its holder.
If the eBike is not moved for approx. 10 min

and

no button is

pressed on the on-board computer, the eBike system
switches off automatically in order to save energy.

eShift (optional)

eShift is the integration of electronic gear-shifting systems
into the eBike system. The eShift components are electric-
ally connected to the drive unit by the manufacturer. The
separate operating instructions describe how to operate the
electronic gear-shifting systems.

Setting the assistance level

You can set the level at which the eBike drive assists you
while pedalling on the on-board computer. The assistance
level can be changed at any time, even while cycling.

Note:

In some models, the assistance level may be preset

and cannot be changed. There may also be fewer assistance
levels available than stated here.

The following assistance levels are available as a maximum:
–

OFF:

Motor assistance is switched off. The eBike can just

be moved by pedalling, as with a normal bicycle. The
push assistance cannot be activated at this assistance
level.

–

ECO:

Effective assistance with maximum efficiency, for

maximum range

–