Sparc E35202-05, Installation Manual

Page: 51 / 62

Assign a Static IP Address to the SP
Powering On the Server Module for the First Time 51
->
set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'
2. Set the IP address for the SP.
->
set /SP/network pendingipaddress=
service-processor-IPaddr
Set 'pendingipaddress' to '
service-processor-IPaddr
'
3. Set the IP address for the SP gateway.
-> set /SP/network pendingipgateway=
gateway-IPaddr
Set 'pendingipgateway' to '
gateway-IPaddr
'
4. Set the netmask for the SP.
->
set /SP/network pendingipnetmask=255.255.255.0
Set 'pendingipnetmask' to '255.255.255.0'
This example uses
255.255.255.0
to set the netmask. Your network environment subnet might
require a different netmask. Use a netmask number most appropriate to your environment.
5. Verify that the pending parameters are set correctly.
->
show /SP/network
/SP/network
Targets:
Properties:
commitpending = (Cannot show property)
dhcp_server_ip = xxx.xxx.xxx.xxx
ipaddress = xxx.xxx.xxx.xxx
ipdiscovery = dhcp
ipgateway = xxx.xxx.xxx.xxx
ipnetmask = 255.255.255.0
macaddress = 00:21:28:C1:6E:C5
managementport = /System/MB/SP/NETMGMT
outofbandmacaddress = 00:21:28:C1:6E:C5
pendingipaddress = service-processor-IPaddr
pendingipdiscovery = static
pendingipgateway =
gateway-IPaddr
pendingipnetmask = 255.255.255.0
pendingmanagementport = /System/MB/SP/NETMGMT
sidebandmacaddress = 00:21:28:C1:6E:C4
state = enabled
6. Commit the changes to the SP network parameters.
-> set /SP/network commitpending=true
Set 'commitpending' to 'true'