Spar SP-500A, Installation, Operation And Maintenance Instructions

Page: 8 / 22

CORRECT USE OF THE MIXER
It is the responsibility of the users to use the
mixer correctly within the recommended
limitations. Always follow the instructions on this
handbook when changing speed. If the motor
labors, stop the machine and reduce the size of the
mix immediately. Damage resulting from
improper use is not covered by the SPAR
warranty.
For operator safety, please turn the speed
selector to the OFF position before install mixing
tools, fixing or moving bowl cradle. Furthermore,
the machine is fitted with a bowl guard which is
electrically interlocker to ensure that the mixer
cannot operate unless the guard is correctly
positioned and the bowl is raised.
For additional safety the mixer has a no bolt
release feature which means that in the event of a
power failure, the machine will only restart after
the ON/OFF Speed Selector Button has been
regressed. This arrangement ensures that when the
power is restored, the machine cannot restart on its
own.
- Careful handling of bagged products by
minimizing the height above the bowl base from
which they are poured.
- Careful slitting of bags in the lower part of
the bowl to allow dust free discharge of flour as
far as possible.
- Using temporary bowl covers to minimize
openings through which flour may escape.
THERMAL OVERLOAD PROTECTION
(Automatically Reset)
The thermal overload protection (circuit
breaker) will shut off and stop the machine
automatically. If this occurs, please turn the
ON/OFF speed selector button to 0-OFF position
and reduce the size of batch. After waiting 1-2
minutes machine shut off, turn the ON/OFF speed
selector or button to ON position. The thermal
overload protection is an automatic reset device.
The circuit breaker may be different base on
mixer’s voltage. *Figure 3 shows the position of
110V(3A) circuit breaker. Figure 4 shows the
position of 220V (2A) circuit breaker.
(a) The locking pin at the rear of the bowl should
locate in the hole of the cradle.
(b) The two weld clips in the bowl handles must
engage on the locating pins located on the cradle.
(c) Latching the bowl locking.
Please ensure that the bowl is seated correctly
on the cradle before securing the bowl locking
latches prior to use.
* 110V(3A) circuit breaker must be manually
reseted.
With the bowl
cradle lowered, place
the chosen mixing
tool in the bowl and
position the bowl on
the cradle. There are
three locational
points for the bowl:
The bowl cradle and
bowl guard are
electrically interlocked
so that the machine will
only operate with the
bowl cradle in the raised
position. Please see
figure 6.
In addition to this,
the bowl guard must be
placed into position by
aligning its two pins into
the two small holes on
the both side of the bowl. Only once the bowl is
raised and the bowl guard locks, the machine can
operate. Thus this ensures complete operator
safety at all times.
For start mixing, raising the bowl lift handle
in 180° anti-clockwise direction to the top. Once
mixing is finished, turn off the machine and lower
down the bowl handle in clockwise direction.
During the mixing process, additional ingredients
can be added by the chute located on the right
hand side of the bowl guard.
Figure 4 Figure 3
Note: Once the circuit breaker over loaded
and shut off the machine happen frequently;
please replace the circuit breaker.
FITTING THE BOWL
BOWL LIFT & BOWL GUARD
Figure 5
Figure 6
SP-500A Desk Top Mixer
4