Spar SP-500A, Installation, Operation And Maintenance Instructions

Page: 7 / 22

INSTALLATION
The machine is lubricated and ready to run. It
can be positioned on any substantial work surface
or bench which is capable of supporting a load of
25kg. For operation stability, please punch four
holes on the table and fix SP-500A onto the table
by four screws. Please see figure 1.
This machine is 15 kgs. The transportation
should require two people. Please see figure 2.
- Electrical equipment is capable of operating
correctly when the relative humidity does not
exceeding 95% at a maximum temperature of
+40ºC.
- Electrical equipment is capable of operating
correctly at altitude up to 1000m.
- Electrical equipment is designed to withstand to
protected against the effects of transportation, and
storage temperature within a range of -25ºC to
+55ºC and for short periods not exceeding 24h at
up to +70ºC.
BEFORE USING THE MIXER
Before using the mixer, please ensure that all
users are familiar with the correct operation of the
machine.
In particular, care should be taken to ensure
that the bowl and mixing tools are correctly fitted
and that the bowl guard is in position prior to
starting the machine.
SAFETY AT WORK
Never place your hand or any kitchen utensil
in the bowl when the mixer is in operation. Isolate
the machine from the electrical supply by
removing the plug from the socket before cleaning
or dismantling.
Do not use the machine with any cover or
guard removed.
Certain operator notice advising about the
safe use of this mixer is attached to the machine.
OFFICE, SHOPS AND RAILWAY
PREMISES ACT
The above Act requires that this machine and
attachments shall be operated only by a properly
instructed person or by an employee who is under
the supervision of a properly instructed person.
The instruction shall include indication of the
possible dangers arising and the precautions to be
observed. The Act also requires that no person
under the age of 18 shall clean a machine if this
exposes him to risk of injury from a moving part
of that machine or any adjacent machine.
MOTOR OVERHEATING PROTECTION
The Motor Overheating Protection will shut
off and stop the machine automatically to protect
motor. If this occurs, please turn the ON/OFF
speed selector button to 0-OFF position and
reduce the size of batch. After waiting 10~15
minutes, please start the machine again.
ELECTRICAL CONNECTION
Before connecting this machine to the
electrical supply, check that the details on the
rating plate (located on the rear of the machine)
correspond to the details of your electrical
connection. The mixer is supplied with a trailing
lead fitted with a molded plug. If the style of plug
is unsuitable for the socket you plan to use, the
plug must be cut off and replaced with an
appropriate plug.
The mixer should be plugged into a switched
socket which isolates all poles and has a minimum
contact clearance of 3mm and located close to the
mixer for use in an emergency and to facilitate
servicing. (max.2 meters of cable) The machine
must be incorporated into a potential equalization
system.
If the electrical supply cable to the machine
becomes damaged, it must be replaced by a
qualified electrician using cable which is 1.0 or
higher and suitable for a 750W motor load. The
ground wire is fixed to the machine and this
connection must be kept intact. This mixer can be
stood on a stable, non-resonating working table of
a height of between 600 and 900 mm.
- The minimum requirement for all electrical
equipment is correct operation between air
temperature of +5ºC and +40ºC.
Figure 1
Figure 2
SP-500A Desk Top Mixer
3