TECHNICAL SUPPORT - tel. +48 71 31 59 068
IN CASE OF ALARM
Turn off the gas supply, shut off the stove. Open the doors and windows.
Before you leave, check if anyone has left in the room. Then leave the
room and do not return. Call the rescue service for help (gas service, fire
brigade, etc.).
INSTALLATION
SC\1B sensor is intended for use in the rooms where the potential risk
resulting from the dangerous concentration of carbon monoxide is the
highest. The device is ideal for kitchens, bathrooms, boiler rooms, ga-
rages etc. When installing the sensor make sure it will be heard from
other rooms in the building as well. Carbon monoxide mixed with car-
bon dioxide is thicker than the air so it is recommended to install the
sensor in the lower part of a wall. The recommended installation height
for bedrooms is 0.5m above the floor. The optimal installation height for
other rooms is 1.5m above the floor.
1.
Separate the mounting base from the body of the device by turning
it anti-clockwise.
2.
Insert two AAA 1.5V batteries into the device.
3.
Test the device by pressing the button on the cover for a few se-
conds. If the device works properly, interrupted signals should be he-
ard from the speaker.
4.
Mark 2 spots for mounting bolts in the desired location, using the 2
holes in the mounting base. Then, drill 2 holes of the proper diameter
in the wall and insert the mounting bolts (included). Mount the base
on the wall using the screws. Attach the body of the device to the
base using 2 hooks in the body, matching the two oblong holes of
the corresponding size, located in the base. When the elements are
fitted turn the body to the right.
5.
Press the TEST button at the side of the cover. The device will run the
test procedure, testing the audible signalization of the alarm. If the
signal is "beep" 0.5 s - pause - 0.5 s etc., and the red LED is not blinking
or is constantly lit, this means that the device is damaged. Contact
the technical support of the importer.
