SpaDealers Polar AquaKing, User Manual

Page: 11 / 11

NOTE:

If the spa is in automatic working mode, please don’t turn off the spa when not in use. Make sure the spa is
always “ on” .

When in automatic mode, the filtration pump will also be controlled by temperature. If the water temperature
is lower than the preset level, during the “OFF” period, the filtration pump and heater will work until the water
temperature has reached the preset level. Then, the filtration pump will return to work for 1 hour and stop for
3 hours repeatedly. When the automatic mode is not in use the circulation pump is always on. If the water
temperature drops 2° under the pre ‐ set level the heater will activate.

Each time the spa is switched on, the system will go into the previously set mode. Press and hold the or
key for 3 seconds (the indicator will show GREEN ) to switch between automatic mode and manual mode.
Summary: and
If is selected the filtration is handled automatically in cycles of “1 hour on, 3 hours off”.
If is selected the filtration pump (and thus the filtration) is on continuously, 24h per day without stopping in between.
If the preset temperature is higher than the actual water temperature then both the circulation pump and heater are activated
until the water temperature reaches the chosen setting. The Ozone will automatically work together with the filtration pump
and heater. This applies in both and modes.
WARNING! The circulation pump also generates heat and if it is running a long time (eg, continuous filtration ) it can raise the
temperature by several degrees in one day when the tub is well insulated. Avoid using the function other times than when
the water needs to be filtered further. Always check water quality and temperature after using for one day.
FILTRATION PUMP ‐ NOTE! If the hot tub is equipped with a massage pump it will connected to "WATER PUMP 1". If there are
two massage pumps the second is connected to "WATER PUMP 2".
UV ‐ C OZONE CLEANER If an UV ‐ C ozone cleaner is installed, connect it so that it activates the same time as the circulatory
pump.
BLOWER (BUBBLE) ‐ ATTENTION! If the blower is used often and for prolonged periods of time, the blowers built in thermal
protection might activate. The blower will stop and not restart until it's cooled down enough. You can speed up the cooling by
opening the service hatch(es). In doing so, please protect the equipment from potential freezing damage.