CLEANING AND CHANGING THE FILTER
C
V
Cleaning /change of filter AquaKing For a good water hygiene it is very important
that the filter gets cleaned on a regular basis. At least every second week it should be
rinsed. Every second month or whenever it is required it needs to get cleaned
“thoroughly” with a special solution.
1.
Open the hatch where filter and circulation pump are placed. Start the pump
(keep the T/A button pressed until it starts) if it’s not already running.
2.
Open the screw (1) for the air above the filter top piece. Close the valve (3) on
the right side of the filter by pressing it down.
3.
Be prepared to close the valve (C) (the one closest to the bottom to the left of
the pump) when the pump stops. This is important to do, so water will not flow
back into the filter cartridge holder.
4.
Unscrew the nut and take off the filter’s top piece. Now it is possible to clean the
filter. It would be good to have a spare one. Assemble it in an opposite order
(tighten the nut on the cartridge holder, leave it slightly loose so it will be easier
to reopen it). Tighten the nuts of the filter container properly. Open 1 & 2 and let
air escape. Close when water starts trickling out. Now the pump can be started
via the control panel.
Draining of water There is a valve (V) close to the circulation pump installed in
order to drain water, see picture to the right. In case the spa bath needs to be
emptied for a longer period or if there might be a risk of frost then please keep in
mind to empty the circulation pump and the massage pump (if included) very
carefully as well.
1.
Open cover where filter and pump(s) are installed. Open valve (V) and drain the
water via the drain hole.
2.
Loosen the lowest nut belonging to the pumps (A). This one does not to be
loosened totally, just so that water can drain. Please do the same with the nuts
of the filter (B) and please do keep them open.
3.
Loosen the nuts which are connected to the bubble system and give the hose a
good blow a few times till water runs out.
4.
NOTE! If the control systems model nr. Is TM42-A1 then the blower air pump
can be started via the control panel. Let it run for a few seconds before turning it
off again.
Attention! When the spa is to be drained of water for a longer period of time, or if
there is a risk of freezing then the circulating pump, massage pumps and nuts for
pumps and filters shall be left open. If draining is done only for changing the water it
is not necessary to drain the pumps of water or open these connections. Also read “Avoid damage from freezing”.
Avoid damage from freezing
Plan the draining and filling of water so that there is no risk of damage from freezing, never empty or fill the bath when the temperature’s
below freezing without first protecting the equipment.
Attention! If the bath has been emptied of water and the temperature’s below freezing then all the equipment will also be below freezing
itself- If the bath is filled with water then without considering this, the risks of freezing damage is great.
For protection against freezing damages the interior of the bath can be warmed up beforehand. Use for instance an interior car heater or
electric heater and set the temp to 20 degrees celsius and place it inside the box where the pumps are installed as well.
If the water level drops below the massage nozzles they are automatically drained of water when the air regulator on the the edge is in
open moden. Is the air regulator is closed then water can remain in the transparent 12 mm hoses and cause freezing damage. Always
keep the air regulator in open mode when draining the spa.
To protect BactiSafe against damage from freezing it should be drained by loosening the stainless nut and the sealing around the glass
tube.
Summary of Contents for Polar AquaKing
Page 3: ...1 2 3 4 ...
Page 4: ...5 6 7 8 ...
