SAFETY INSTRUCTIONS
• The heating element must not be installed directly below a wall socket.
• The installation of an infrared heating element in special rooms (rooms with shower, bathtub
or swimming pool) as well as in public places may only be done by a specialized installation company
taking into account the appropriate standards and norms of the country concerned.
• The infrared heating element may only be connected to alternating current 120 Volt, 50Hz.
• The infrared heating element must not be exposed to excessive moisture.
• Do not put down objects on the infrared heating element and do not cover the infrared heating
element !! Attention: risk of overheating !!
• The infrared heating element is equipped with a safety temperature limiting device, which
turns off in case of overheating and automatically turns on again after cooling down.
• The plug needs to be switchable without tension at all times during operation by switch or thermostat.
• The minimum distance to other objects should be 20 inches (50 cm) away from the front, 8 inches (20
cm) to the sides and 8 inches (20 cm) upward and downward.
• For the installation of an infrared heating element on a brick or stone wall, only the holding and fixing
material provided for it must be used. On other types of wall or masonry (as e.g. Rigips, wood, …)
please use suitable holding and fixing material.
• In case of possible disassembly or transport allow the infrared heating element to completely cool
down.
• The infrared heating element is not meant to be handled by persons (children included) with reduced
physical, sensorial or mental faculties or without experience and/or knowledge, unless they are super-
vised by a person responsible for their safety or receive instructions on how to use the device.
• Children never see the danger, which can occur when dealing with electrical devices. So never leave
children alone with electrical devices. Keep out of reach of small children. If the device is installed in
children’s rooms or rooms accessible to children, make sure that the device is suspended 1.2m above
the ground.
• Do not try to repair the infrared heating element, the power cable cannot be replaced and must always
be returned to the manufacturer for repairs.
• DO NOT TOUCH THE HEATER’S SURFACE WHEN IT IS SWITCHED ON.
Instruction Manual
In this manual there is important information for the installation of your infrared heating element. You
have acquired an ecologic, economic heater and are thereby making an effective contribution towards
saving the environment. This heater can be used with a thermostat.
The infrared heating system proves itself through simple installation, flexibility in the assembling and
freedom from maintenance. So you can enjoy long use of your infrared heating element and to assure
your safety, please read carefully the instructions before installation.
Keep this manual at hand and never pass on this infrared heating element without the manual.
The infrared heating element does not work on the principle of convection heat but is rather a radiant
heater. Therefore, it is possible at the start-up that cold areas (furniture, walls, ceiling and floors) need
to be warmed up first. If you don’t immediately have a comfortable feeling of warmth, then let the heater
run for several hours, or even several days if necessary, until a comfortable indoor climate has been
reached. As soon as the solid areas have warmed up, comfortable warmth will spread throughout the
room and then you can pare down the running time of your heater to the minimum.
!
