5
Assembly of the elevator
1. Insert the 300mm shaft into the
gearbox (fg. 06-1)
2. Slide the elevator (12 pcs) onto
the 300mm shaft (fg. 06-2
Please note the correct direction
of rotation
3. Insert 3 further 300mm shafts
into the exact pre-defned
positions on the gearbox (fg. 06-3)
4. Allow the 3 shafts to snap into
place (pic. 06-4). Take care that
the elevator rings are properly
located
See pages
6+7
for the proper
locations of the elevator rings
5. Insert the 4 shafts into the
elevator cover (fg. 06-5). Take
care that the shafts are properly
located
6. Now attach 3 rail stands [A6] to
the elevator ring (fg. 06-6)
06-1
06-2
06-3
06-4
06-5
06-6
4
[S1] Shaft 300mm
[E1] Elevator helix
[S1] Shaft 300mm
Please note the correct direction
of rotation
Make sure convex red parts point up
and everything is correctly seated
Assembly of the elevator
[G1] Gearbox
[E2] Elevator ring
[E3] Elevator cover
[A6] Rail stand
[A6] Rail stand
Avoid that there is a gap between
gearbox and elevator helix. Otherwise
the elevator will not operate properly