– 13 –
Inverter Air-to-Water Heat Pump
Time Power On and Off Setting Display
The function of parameter preservation and timing are operated by controller. The wire controller can only display and set the timing
time. No matter when it starts or terminates functioning, the timing power on and off key on the main display remains green. When it
does not conducting this function, it will be white.
Timer Full Closed
1. When the timer are full closed, the ‘On’ button and ‘Off’ button will turn grey. When the time interface is all grey, it means the timer
function has not been activated.
2. Press ‘On’ button and the button will be lightened, then power on timer can be set. Press ‘On’ button repeatedly to switch
between timer on and off.
3. Press ‘Off’ button and the button will be lightened, then power off timer can be set. Press ‘Off’ button repeatedly to switch
between timer on and off.
4. When the timer is under closed status, the time could not be set.
Only Use ‘On’ Timer
1. When using only power on timer, the ‘On’ button will be lightened as illustrated above.
2. Then the unit will power on once at the according ‘Hour’ and ‘Min’ and no more start-up will be conducted at other timing.
3. Under this status, other operation on the display should follow ‘Timer Full Closed’.
Return
Start on
Start off
Start hour
Start min
End hour
End min
Summary of Contents for SIM-036
Page 4: ... 4 Inverter Air to Water Heat Pump Specification Unit Dimensions inch SIM 036 SIM 060 ...
Page 29: ... 29 Inverter Air to Water Heat Pump Section 6 Wiring Diagrams Definitions ...
Page 44: ... 44 Inverter Air to Water Heat Pump Troubleshooting Chart Possible Cause Possible Solution ...