7
The FB code is the stop time of the common fan and burners before any burner ignition. We
Factory set this at 8 but can be adjusted to anything between 2 and 250 seconds. To set this
Scroll through the parameters until you come to FB then Press
, using
scroll
to the desired setting, we factory set this to 8 if a common fan is used.
The FBF code is the stop time of common fan and burners after any burner ignition. We
Factory set the at 8 but can be adjusted to anything between 2 and 250 seconds. To set this
Scroll through the parameters until you come to FBF then Press
, using
scroll
to the desired setting, we factory set this to 8 if a common fan is used.
Once you have set both the FB and FBF settings reset the unit by pressing and holding the
power button
until OFF is displayed then press the power button
to turn the unit
back on.
See section 4.2 on page 2 and 3 as well as Section 17 on page 6 in the manual for
more help.
5. FN is to Enable the Zones, Automatically, Manually or via Time settings as well as
Enable the Burners.
Press
(SET will be displayed) then ,
then,
then,
this will display FNC.
Press
this will display AN-1, this is
ZONE 1, (if there is more than one they will be AN-2, AN-3 or AN-4) if then press
this
will give you the first option which will be ON, if you press
you can change this to Auto
or OFF. Press
once you have set the zone. See Section 11.2 on page 4 of the manual.
Once you have the Zones set to Manual. Auto Or Off. If you continue to scroll through the
menu options from AN-1 by pressing
then
again En-1 will display. This is your
Burner Enable options. Press
then the
key you can enable or disable the burner.
See section 11.3 on page 5. You can repeat this to set EN-1 to En-4.
