6
Once you have set all your ONs and OFFs you can review all the programs you have set by
Pressing
(SET will be displayed) then,
then,
then,
Fnc will be displayed
then press
. AN-1 will be displayed, press
and AUTO will be displayed. Press
.
Then using the
key you can scroll through all the timer settings that have been set up
and add more if required.
See section 11.2 on page 5 of the manual for more information.
4.PAR Used to access all the parameters from Fan set up, Zone Qtys, Burner Qtys
Press
(SET will be displayed) then,
then,
this will display PAR. Press
this
will then display PA. Press
Again. This is where you now enter the Password for the unit
to change the
Parameters, this can be locked by the customer with there own password. Use Installer
Password 95 or Factory Password 59. Please see page 7 of the manual under section 17.
Press the
to enter the passcode required then Press
. You can then use the
to scroll through all the parameters found in section 17 on page 6 of the manual
and section 4.2 on page 2 to find the desired H5 parameter.
When we set these up to send to the customer we will only set the H5, FB and
FBF codes.
The H5 code is the code to set the Operation mode for heating zones, sensor connections
and common AUX fan if fitted. Scroll through the parameters until you come to H5 then Press
, using
scroll to the desired operation mode as shown in section 4.2 on page
2 and 3, for example H5=12 is 3xZones made of 1x single stage independent heater each +
Common exhaust fan. Press
again, this will take you back to the H5 Display. Press
. Then reset the unit by pressing and holding the power button
until OFF is
displayed then press the power button
to turn the unit back on.
