Space-Ray LRDL15, Assembly, Installation And Operation Instructions

Page: 23 / 51

Form #44201117
-22- Dec 2021
8. Check to ensure that the hardware is completely closed and the band is seated on the reaction block and
interference pins as illustrated above.
9. Once all the heater body sections are attached, make sure that the heater system is sloped up to the fan. If
it is not, slight adjustments can be made using the turnbuckles. (See Section 8.1)
9.2) INSERTING TURBULATORS
1. Assemble the turbulators together by interlocking the slotted end portions.
2. Slide these into the last tube section located at the fan as shown for Linear Model heaters.
3. Align turbulator end flush with end of tube.
Note: Refer to the table below for quantities of turbulators required for each heater section.
Fig. 13b
Important: NEVER reuse a coupling. Always install a new coupling only and
torque as per instructions above and the diagrams above.