A: CONNECTION TO CABLE
1
REMOVE EXISTING LIGHT
3
CABLE PREPARATION
2
DISCONNECT EXISTING LIGHT
NOTE
IF CABLE LENGTH ALLOWS,
CUT CABLE BACK UNTIL
FRESH COPPER APPEARS.
STRIP POWER CABLE TO
SPECIFIED LENGTH
55/64”-3/4”
(22-19mm)
23/64” (9mm)
REMOVE EXISTING LIGHT FROM NICHE AND
BRING TO THE SURFACE FOR CONNECTION
ENSURE YOU DON’T DISTURB
THE BONDING CABLE
ALL CABLE CONNECTIONS ARE TO BE DONE
AT SURFACE LEVEL, AND OUT OF WATER
DISCONNECT LIGHT
FROM POWER CABLE
ENSURE BONDING CABLE
IS NOT CUT OR DISTURBED
CUT POWER CABLE
AS CLOSE TO BACK OF
EXISTING LIGHT AS POSSIBLE
WATER
LEVEL
POWER CABLE
TO LOW VOLTAGE TRANSFORMER
STOP! WARNING
ELECTROCUTION
CHECK POWER IS
TURNED OFF
FIRST
INSIDE
NICHE
BONDING
CABLE
POWER
CABLE
EXISTING
LIGHT
7
