BIOS Setup
27
UR2 Duplex Mode
Choose Half or Full to set UR2 in half
duplex mode or full duplex mode. Refer
to your IR device specification to select
the suitable mode. (This option appears
only when you choose UR2 Mode other
than ÒNormalÓ.)
Use UART2 Pins
Choose IR-RX2TX2 or RXD2TXD2 to
set the IR output port you want to use.
IR-RX2TX2: Choose IR-RX2TX2 when
you have 5-pin infrared
device on IR connector and
you could only use half
duplex function in this
mode.
RXD2TXD2: Choose RXD2TXD2 when
you have serial infrared
device on COM2 and you
could use both full/half
duplex functions in the
mode.
Onboard Parallel Port
Choose the printer I/O address:
378H/IRQ7 (default), 3BCH/IRQ7,
278H/IRQ5
Parallel Port Mode
Choose ECPEPP1.9 (default), EPP1.7,
ECPEPP 1.7, PS/2, EPP1.9, ECP, or SPP.
The mode depends on your external
device specification that connects to this
port.
ECP Mode Use DMA
Choose 3 (default) or 1 to select DMA3 or
DMA1 when using the ECP device.
USB Controller
Enable it when you are using the USB
device.
3.
After you have finished with the Integrated Peripherals, press the
<ESC> key and follow the screen instructions to save or disregard
your settings.