10
Hardware Setup
2.
COM1/COM2 Connectors
Connect COM1/COM2 devices to these connectors. (Please
order type A COM port cable when you lose your original cable.)
3.
FDC Connector
Attach floppy cable to this connector.
4.
J19 – Hardware Reset Control
Attach the Reset switch to J19. Closing the Reset switch restarts
the system.
5.
J24 – HDD LED Connectors
Attach on-board hard disk drive LEDs to this connector. The
LED lights when an HDD is active.
6.
IR – IR Connector
A four-pin wafer connector is for connecting to the IR device.
Use the device that has the ASKIR or HPSIR specification and
choose ASKIR/HPSIR from the BIOS setup.
7.
J1 – Keyboard Connector
A five-pin female DIN keyboard connector is located at the rear
of the board. Plug the keyboard jack into this connector.
8.
J17 – Keylock & Power LED Connector
J17 is a connector for a lock that may be installed on the system
case for enabling or disabling the keyboard. J17 also attaches to
the caseÕs Power LED. (Pin 1, 3 for power LED, pin 4, 5 for
keylock.)
9.
IDE1/IDE2 – On-board Primary/Secondary IDE HDD
Connectors
Attach on-board hard disk drives to these connectors.
10. PRT – Parallel Port Connector
Attach parallel port cable to this connector.