3.3.2 Get IP address by DHCP Server
AR-727CM support Auto Configuration of the IP and gateway addresses and subnet
mask function, but must make sure the DHCP Server is active. The steps as follows:
Step 1: Switch DIP Switch position to OFF, OFF, OFF, ON.
Step 2: Power cycle the device
Step 3: In begging state the ACT LED will flashing, after IP has got ACT LED will off
and auto save the new IP address to EEPROM.
Step 4: Switch DIP SW-4 to “OFF” position and move DIP SW-1 and SW-2 to “ON”
position
Step 5:To modify parameter on the AR-727CM through the Hyper-Terminal function of
the Window.
(Start
→
Programs
→
Accessories
→
Communication
→
Hyper Terminal)
Step 6: Click “Hyper-Terminal”.
Step 7: key-in any temporary name.
Shown as follows: It is not important matter.
Step 8: Choose which COM port Step 9:
Set Port Settings to 9600, 8, None, 1,
and click OK to exit. None and click “OK” to save.
8
