PalletPal Stretch Wrapper
8 PALLETPAL STRETCH WRAPPER OWNER’S MANUAL
SPECIFICATIONS
Load capacity:
2500 lbs. uniform load
Load size:
50” wide x 50” long x 65” high
Power:
115V AC, 10, 60Hz, 6 amp
Film capacity:
10” dia. x 12”
to 20” long 90-1/2” long
Length overall:
90-1/2”
Height of mast:
60-3/8”
Height
(film carriage
raised, 20” film):
66-3/4”
Turntable ramp dia:
49-7/16”
Turntable
diameter:
43 3/8’’
Turntable height:
1’’
Speed:
8.25 rpm
Controls:
Footswitch, momentary contact
Net weight:
Approximately 600 lbs.
Unpacking the Lift
The PalletPal Stretch Wrapper unit has been pre-wired
and pre-assembled. It was tested to factory specifications
before shipment.
1. Before you start to install the unit, check for local
codes and ordinances, which may apply. It is your
responsibility to obtain any necessary permits.
2. Please read all of these instructions carefully. Be sure
to read and understand all of the warnings.
3. Inspect the shipping crate carefully for any damage
that may have affected the machine. If you see signs
of damage, tell the trucker. Also make a note of this on
the shipping papers which you are asked to sign.
4. Choose the place where you want to mount the unit.
It is extremely important that the PalletPal Stretch
Wrapper be set up on a smooth and flat surface.
Check the floor surface carefully and make sure that
it is free of all loose debris and dirt.
Danger!
The electric motor used in the unit can create
sparks. Don’t use the unit in an area where flam
-
mable gases may be present.
INSTALLATION
INSTRUCTIONS
Turntable
Belt guard
Tension adjustment
Mast for film
carriage
Film carriage
Lag bolts
