12
Southworth Products
PalletPal 360 Manual
11. Reinstall the motion stabilizer and secure with
the pin.
12. Additional springs, if needed, can be installed
by inserting them into the bayonet openings.
13. Install the yellow bayonet by inserting them
into the bayonet openings and turning them
clockwise into the locked position. Secure with
the black clip locks.
4.2 Range 0 & Machines with Bellows Skirts
Range 0 machines are supplied with a single white spring. This spring is installed at the factory
and the machine will be shipped in the raised position. Upon receipt inspect the machine for
damage. No further setup is necessary.
Machines equipped with bellows skirts are typically shipped with springs installed and in the raised
position. Upon receipt inspect the machine for damage. No further setup is necessary.
4.2.1. Spring Locations
Range 1 machines will have one orange spring located on the roller end of the machine. Springs
for ranges 2, 3, and 4 to be located as shown below.
Orange
spring
Range #1
Hinge End
Roller End
Orange
spring
Gray
spring
Purple
spring
Range #2
Hinge End
Roller End
Orange
spring
Range #3
Hinge End
Roller End
Purple
spring
Orange
and Gray
springs
Range #4
Hinge End
Roller End
CLIP LOCK LOCATED ON
EACH BAYONET (SHOWN
IN LOCKED POSITION)
Clip locks not shown in this image
