IMPORTANT SAFETY
INSTRUCTIONS
BEFORE USING YOUR TELEPHONE EQUIPMENT,
BASIC SAFETY PRECAUTIONS SHOULD ALWAYS
BE FOLLOWED TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK AND INJURY TO PERSONS,
INCLUDING THE FOLLOWING:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the
product.
3. Unplug this product from the wall telephone jack and
power outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp cloth for
cleaning.
4. Do not use this product near water, for example, near
a bath tub, wash bowl, kitchen sink, or laundry tub,
in a wet basement, or near a swimming pool.
5. Do not place this product on an unstable cart, stand
or table. The product may fall, causing serious
damage to the product.
6. Slots or openings in the cabinet and the back and
bottom are provided for ventilation, to protect it from
overheating. These openings must not be blocked
or covered. The openings should never be blocked
by placing the product on a bed, or other similar
surface. This product should never be placed near
or over a radiator or heat register. This product should
not be placed in a built-in installation unless proper
ventilation is provided.
7. This product should be operated only from the type
of power source indicated on the marking label. If
you are not sure of the type of power supply to your
home, consult your dealer or local power company.
8. Do not allow anything to rest on the power cord. Do
not locate this product where the cord will be abused
by persons walking on it.
9. Do not overload wall outlets and extension cords as
this can result in the risk of fire or electric shock.
Never spill liquid of any kind on the product.
10. Never push objects of any kind into this product
through cabinet slots as they may touch dangerous
voltage points or short out parts that could result in
the risk of fire or electric shock.
11. To reduce the risk of electric shock, do not
disassemble this product but take it to a qualified
serviceman when some service or repair work is
required. Opening or removing covers may expose
you to dangerous voltages or other risks. Incorrect
reassembly can cause electric shock when the
appliance is subsequently used.
12. Unplug this product from the wall outlet and refer
servicing to qualified service personnel under the
following conditions:
a. When the power supply cord or plug is damaged
or frayed.
b. If liquid has been spilled into the product.
c. If the product has been exposed to rain or water.
d. If the product does not operate normally by
following the operating instructions. Adjust only
those controls that are covered by the operating
instructions because improper adjustment of other
controls may result in damage and will often
require extensive work by a qualified technician
to restore the product to normal operation.
e. If the product has been dropped or cabinet has
been damaged.
f. If the product exhibits a distinct change in
performance.
13. Avoid using a telephone (other than a cordless type)
during an electrical storm. There may be a remote
risk of electric shock from lightning.
14. Do not use the telephone to report a gas leak in the
vicinity of the leak.
Save These Instructions
CONGRATULATIONS!
You have purchased a 13 MEMORY DESIGNER
SLEEKLINE TELEPHONE manufactured to the highest
standards of Southwestern Bell Freedom Phone
®
. Before
installing and operating, be sure to read this Owner’s
Manual.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
UNPACKING
Carefully remove your telephone from its carton. In
addition to the HANDSET and telephone base, the carton
should contain the following:
• One 10-ft. modular coil cord
• One 7-ft. modular telephone line cord
• One 5-in modular telephone line cord
• Owner’s manual / Warranty card
• One additional memory index
1. Key Pad
2. Flash Button
3. Reset Button
4. Redial Button
5. Handset
6. Receiver Volume
Control
7. Tone/Pulse Switch
8. Memory Index
9. Dial Tone Reset Key
(Hook Switch)
10. Base
11. Memory Button
12. Ringer Off/Low/High
Switch (on bottom of
base)
13. Mute Button
14. Store Button
15. Coil Cord
INSTALLATION
FOLLOW THESE PRECAUTIONS BEFORE
INSTALLATION:
1. Never install telephone wiring during a lightning storm.
2. Never install telephone jacks in wet locations unless
the jack is specifically designed for wet locations.
3. Never touch uninsulated telephone wires or terminals
unless the telephone line has been disconnected at
the network interface.
4. Use caution when installing or modifying telephone
lines.
1. MEMORY INDEX CARD
a. Insert a paper clip into the MEMORY INDEX CARD
COVER and pry it out.
b. Write on the card the person’s name and number that
you stored in the memory.
c. Replace the COVER.
2. USING THE PHONE ON A DESK
a. Plug the 7” telephone line cord into the jack in the
bottom of the BASE, thread it through the groove
toward the back of the unit, then plug it into the
modular wall jack.
b. Connect the COIL CORD to the jacks in the
HANDSET and the BASE.
3. HANGING THE PHONE ON THE WALL
When the FC2548/FM4000 is wall-mounted, the
HANDSET GUIDE serves to hold the HANDSET in place
in the cradle.
1
2
3
4
Sold by:
http://www.TWAcomm.com
Toll Free: (877) 892-2666
