Southwest Graphic Whizard PT320 CC, Setup & Operator Manual

Page: 20 / 53

2-2 Operation panel
(1) Back of the panel
● Mode changeover key: Standby, changeover to the cutting mode, return
to standby state after setting parameters.
● Parameter setting key: used to adjust the cutting size and set the cutting
paper number
● Start (+) key: start cutting when in the standby state; increase the value in
the cutting size adjustment
● Stop(-) key: stop cutting during a job; decrease the value in the cutting
size adjustment
● LCD screen: display the cutting mode and counting
(2) LCD display
After the power is turned on, the machine starts initialization and then
goes into the standby state. The said state means the machine has finished
initializing but not entered into the cutting mode (the machine is stopped),
the LCD in the standby state will display:
LCD
screen
Mode changeover
Parameter set
Key
Start (+)key
Stop(-) key
12