INSTALLATION
FIELD ASSEMBLY INSTRUCTIONS AND DIAGRAMS:
The following section covers Field Assembly instructions for the Compact Infra-Red Broiler combinations noted
below and shown on Page 1, Section 1.
1. Installing legs for counter units.
Page
Model No. MRA-32C
4
2.
Assembling wall mount and attaching unit.
Model No. MRA-32C
5
3.
Assembling flue riser and attaching unit for mounting over 32" Sectional Range.
Model No. MRA-32
7
4.
Assembling flue riser and attaching unit for mounting over
36%"
Cafe Range.
Model No. MRA-36
9
5.
Assembling flue riser and attaching unit for mounting over 60%" Cafe Range.
Model No. MRA-60
11
MODEL NO. MR-32C OR MRA.32C
INSTRUCTIONS: For Legs and Rear Spacers on Counter Models
1. Remove the broiler from the container.
CAUTION:
INSURE BURNER SHIPPING SCREWS HAVE NOT BEEN REMOVED.
2.
Carefully lay the broiler on its back.
3. Install each leg "L" packed in the grease drawer with (4) if 10 x
%
slotted sheet metal screws and (8) flat washers in
existing 5/32 holes in the main bottom as shown (hardware packed in cloth shipping bag).
4. Stand the broiler on its legs and install shoulder bolt "B" at the rear of the broiler in 1/4 diameter existing holes with (1)
flat washer, (1) locknut and (1) #10-24 hex nut as shown in inset. This will insure a space in the rear of the broiler for
entrance of primary air.
NOTE: Bottom Cover (Part No. 1078600) is shipped with broiler but is not used on Counter Model.
COMPACT INFRA-RED BROILER
SECTION ONE — INSTALLATION
PAGE 4
Litho in U.S.A
Rev. 741
