INSTALLATION
MODEL NO. MRA-32
DIAGRAM FOR MOUNTING
MRS-32 SECTIONAL 32" RISER TO RANGE
1. Front panel "A" is fastened with (4) hex head sheet metal screws. Remove screws and panel.
2. Remove nuts and lockwasher from collar plate studs "C" on range.
3. Lower riser onto range allowing studs "C" to enter holes in riser bracket "B." Secure riser bracket "B" with nuts and
lockwasher removed in instruction No. 2.
4. The oven flue riser extension "D" (12" high) is packed in oven. Slide flue riser extension "D" over the flue collar "E"
protruding through the center opening of the collar plate "F."
NOTE: On units where the top of flue collar "E" is approximately 4" above collar plate "F," the flue riser extension "D" is
not required.
5. Install angles "H" packaged in riser container with slotted hex head screws provided, into holes in rear riser bracket "B"
and match drill 9/64" diameter holes in range body for mounting angle "H" to range with slotted hex head screws
provided.
6. Install unit (see instructions on page 8).
7. Replace front panel "A" and fasten with sheet metal screws that were removed in instruction No. 1.
8. U-shaped channel "G" is provided for all batteried ranges. Place U-shaped channel "G" over angles on adjacent ranges to
form a sanitary sealing between ranges.
COMPACT INFRA-RED BROILER
SECTION ONE — INSTALLATION
PAGE 7
