Figure 15. Top plate installation.
22. Reinstall the top plate as shown in Figure
15.
17. Make sure the copper plug is still inside of
the slide block.
18. With the help of an assistant, raise the taper
attachment underneath the slide block, so
the pivot pin slides into the pin bore in the
slide block (see Figure 12).
19. With your assistant aligning the taper
attachment mounting holes, use an 8mm
hex wrench to tighten the four mounting cap
screws and secure the taper attachment to
the carriage face (see Figure 12).
20. Using a 4mm hex wrench, snug the slide
block set screw so the copper plug is slightly
preloaded against the pivot pin (see Figure
13).
Figure 12. Taper attachment installation.
Mounting
Cap Screw
Figure 13. Pin adjustment.
Pivot Pin
Pin and Pin
Bore
21. Apply drops of oil liberally at all four way oil
ports, both slide block ways, and the pivot
pin shown in Figure 14.
Figure 14. Lubrication locations.
Ball
Oilers
Slide Block Ways
Pivot Pin
Ball
Oilers
23. Slide the deadman clamp onto the lathe
way, thread the arm clevis into the taper
attachment, and then slide the arm clamp
onto the deadman arm, as shown in Figure
16. Do not tighten the mounting cap screws
or arm clevis at this time.
For Product Mfg. Since 1/10
Model SB1269
-7-
P R E P A R A T I O N
