South bend SB1025F, Manual

Page: 55 / 104

For Machines Mfg. Since 8/09 SB1024/SB1025/SB1026
-49-
M A I N T E N A N C E
Maintenance Schedule
Each operator of this machine is responsible
for ensuring proper care of the equipment. We
strongly recommend that all operators make
a habit of following the daily maintenance
procedures.
For optimum performance from this machine,
this maintenance schedule must be strictly
followed. Use the Monthly Maintenance Chart
on Page 50 to ensure this is done.
Ongoing
To maintain a low risk of injury and proper
machine operation, if you ever observe any of the
items below shut the machine down immediately,
disconnect it from power, and fix the problem
before continuing operations.
• Loose mounting bolts or fasteners.
• Worn, frayed, cracked, or damaged wires.
• Emergency STOP button not working
correctly.
• Missing belt guards.
• Reduction in braking speed or efficiency.
• Coolant not flowing correctly.
• Any other unsafe condition.
Always disconnect
machine from power before
performing maintenance or
serious personal injury may
result.
!
Before Beginning Operations
• Make sure the electric box door is closed and
properly latched.
• Turn the spindle direction switch to the off
(middle) position to prevent spindle startup
when connected to power (see Page 29).
• Move the spindle speed range selector to
the manual (forward) position to prevent
the spindle from unexpectedly downfeeding
when rotation is started (see Page 43).
• Make sure the X-axis power feed is turned
OFF to prevent unintentional table
movement when connected to power (see
Page 31).
• Check the coolant reservoir in the base for
fluid/debris build-up. Clean out if necessary
(see Page 56).
• Perform lubrications tasks as directed in the
Lubrication section on Page 51.
• Check table movement in all three axes
directions for loose/tight gibs. Adjust the gibs
if necessary (see Page 58).
Daily, After Operations
• Push the emergency STOP button and
disconnect the machine from power.
• Vacuum/clean all chips and swarf from table,
slides, and base.
• Wipe down all unpainted or machined
surfaces with a good quality rust
preventative.