SA260
Nemesis Delay User’s Guide
43
Power
200 mA @ 9V DC
Center negative, Barrel positive plug, 2.1 mm inner diameter, 5.5 mm outer diameter
Audio Performance
Maximum Input Level: +6.54 dBV = 8.76 dBu = 2.12 V RMS = 6.0 V p-p
Full Scale Output Level: +6.54 dBV = 8.76 dBu = 2.12 V RMS = 6.0 V p-p
Input Impedance: 1 MegaOhm (1 M
Ω
)
Output Impedance: 600 Ohm (600
Ω
)
110 dB DNR Audio Path
24-bit Audio Conversion
56-bit Digital Data Path
Universal Bypass (relay-based true bypass and analog buffered bypass)
Troubleshooting
Restore Factory Settings
In order to revert the Nemesis to its factory settings, clearing all user data, presets, expression
mappings and custom effect engines, use the Neuro App and choose the Factory Reset option. It is
also possible to perform a factory reset without the Neuro App by following these steps:
Press and hold the T
AP
F
OOTSWITCH
.
Connect the power supply.
The C
ONTROL
L
ED
will blink rapidly until the reset is complete. You can stop holding the T
AP
F
OOTSWITCH
once the C
ONTROL
L
ED
starts to blink.
Noise
Power source:
Ensure that the proper power supply is being used.
Near noise source:
Move pedal away from power supplies and other equipment.
Other equipment:
Remove other effects from signal chain; see if noise persists.
Bad cables:
Swap out audio cables.
USB ground loop:
When connected to a computer using a USB cable, noise can appear in the audio
signal. This usually results from ground loop noise due to the Nemesis and computer running on
separate power supplies. In the case of laptops, the noise can often be mitigated by disconnecting
the computer’s power supply and running it on a battery. External display monitors are often the
primary source of noise, and powering down monitors can also resolve noise issues.
Ground loop with amp:
Make sure your Nemesis is running on the same power mains circuit as your
guitar amplifier.
Hot Hand Doesn’t Work
Low power:
Ensure that the proper power supply is being used.
Not calibrated properly:
Calibrate the Hot Hand. See the
Hot Hand Input
section for more details.
