SYSTEM PROGRAMMING -
Menu 1
PAGE 9
INSTALL MANUAL
TRANSMITTER PROGRAMMING
WIRE DESCRIPTION
SHOCK SENSOR INPUT
SYSTEM PROGRAMMING -
Menu 1
PAGE 8
INSTALL MANUAL
SYSTEM WIRING
PIN 4
Red
PIN 3
Black
PIN 2
Green
12 Volt Output For Auxiliary Sensor.
The Data Port Connector Is Used For Fortin and I-Data Bypass Modules As Well As Compatible
Tracking Units.
Ground Output For Auxiliary Sensor.
Full Trigger Input For Auxiliary Sensor.
PIN 1
Blue
Warn-away Input For Auxiliary Sensor.
ANTENNA/ VALET / PROGRAMMING SWITCH
For maximum range mount the Antenna in the center of the windshield, behind the rear view mirror.
The antenna also contains the program/ valet switch as well as status LEDs for system status and
diagnostics.
DATA PORT
AL.3
AL.3
The supplied dual stage shock sensor connects directly to the module. If a secondary sensor is
being installed the wiring for the connector is as follows.
PROGRAMMING ADDITIONAL TRANSMITTERS
ARM
PM
12:15
PAGER
1
F
PROGRAM
The system can lean up to 4 different remote transmitter codes. Each remote to be used
MUST be programmed together during the same sequence. For security, when a new remote is
programmed all previous remote’s that are not reprogrammed at this time will be deleted.
1- Cycle the ignition key ON-OFF-ON-ON.
2- Press and hold the Button on the antenna, the park lights will turn on and the siren/horn
(optional) will chirp/honk once. (Continue Holding antenna Button).
3- After 5 seconds the park lights will turn off and the siren/horn will chirp/honk 5 times to
indicate you have entered Transmitter Learning Mode.
4- Press the Lock Button on each of the transmitters to be programmed.. The park lights will
flash and siren/horn will chirp/honk once to indicate successfully learning of each transmitter.
5- Turn the ignition key OFF to exit remote Program mode.
DUAL CAR OPERATION (CAR-1 / CAR-2)
2 WAY REMOTE ONLY
The 2way remote transmitter can be programmed to a second vehicle to
control the alarm and remote starter feature. By default the remote is set to
CAR-1, this is indicated by number 1 on the LCD screen. In CAR-1 the LCD
back light is blue, in CAR-2 mode the back light is red.
The second vehicle must also have the same model 2way starter installed. To
Program the remote in second car mode,
1- Press and hold the # Button until the Program icon appears.
2- Press and release the Lock Button until the number 1 icon turns on.
3- Press the Trunk Button to change form 1 to 2.
4- Press # to exit.
Now that the remote is set for CAR-2 “2". You can Program it along with the other remote’s to
the second vehicle. The remote now control the second vehicle functions. To go back to CAR-1
operation follow the steps above. Press the Unlock Button instead of Trunk to change back to
CAR-1 “1".
