ALARM STATUS / DIAGNOSTICS
ALARM STATUS / DIAGNOSTICS
SIREN CHIRPS
LED FLASHES
DIAGNOSTICS / STATUS
3
2
SHOCK SENSOR TRIGGER
3
3
DOOR / HOOD TRIGGER
3
4
IGNITION TRIGGER
0
OFF
SYSTEM DISARMED
0
ON SOLID
SYSTEM IN VALET / SERVICE MODE
0
SINGLE FLASHES
SYSTEM ARMED
0
RAPID FLASHES
PASSIVE ARM COUNTDOWN
LED FLASHES
OUTPUT DIAGNOSTICS
2
LOCK OUTPUT OVERLOAD
3
UNLOCK OUTPUT OVERLOAD
4
TRUNK OUTPUT OVERLOAD
5
STARTER DISABLE OVERLOAD
6
NOT USED
7
AUX 5 OUTPUT OVERLOAD
8
2ND UNLOCK OUTPUT OVERLOAD
If the alarm system is triggered, the system will retain in memory the cause of the
trigger. When disarming the alarm, the siren/horn will chirp 3 times to indicate the
alarm had been triggered. The system’s LED will also flash in pulses to indicate
which input triggered the alarm.
*LED status will be cleared when the ignition is turned ON. For proper memory
clearing, insure to connect the alarm ignition input to the ignition on the vehicle.
If an output from the alarm is shorted the siren
will
chirp
4
times
and
the
park
lights
will
flash
4
times when the system is armed or disarmed. The LED
will
flash a
diagnostic code that represents the circuit that is at fault. (See Chart Below). Turning
the ignition to the on then off position will reset the diagnostic code.
SYSTEM PROGRAMMING -
Menu 1
PAGE 11
INSTALL MANUAL
DIAGNOSTICS
SYSTEM PROGRAMMING -
Menu 1
PAGE 10
INSTALL MANUAL
SHOCK SENSOR
AL.3
AL.3
If the system has been triggered (shock sensor, door input..), the siren will sound for
approximately 60 seconds. Press and release the lock or unlock button to silence the
siren (the system will remain armed). Press the unlock button to disarm the system. The
siren will chirp and the park lights will flash three times to indicate the system had been
triggered.
If the shock sensor is triggered 3 times in a row the system will ignore the shock sensor
until the ignition is turned cycled on then off.
SHOCK SENSOR ADJUSTMENT
The supplied dual stage shock sensor connect’s directly to the shock sensor connector on the
remote starter module. The adjustment screw on the sensor will increase or decrease the
sensitivity. The first and second stage are controlled by the same adjustment screw.
Test the alarm sensitivity then adust as required. If the alarm is triggered 3 times in a row you
will need to cycle the ignition on then off to reset the shock sensor before testing again.
NOTES
Adjustment Screw
Zone LEDs
Mounting Bracket
Use the mounting bracket’s to firmly attach the
shock sensor to the under dash area of the vehicle
before setting the sensitivity.
