ETSA2ØØR 5.13
TECHNICAL SPECIFICATIONS
Size Amplifier:
2.3”H x 5.4”W x 4.6”D
Input Voltage:
10 - 30 Vdc (negative ground)
Input Current:
8 Amps @ 13.6 Vdc (100W speaker)
Standby Current:
<1 mA
Audio Frequency:
200Hz - 10 kHz + 3db
Output Power:
100 WATTS RMS MAX. (11 Ohm Speaker Impedance)
Siren Frequency:
675Hz - 1633Hz
High Voltage Protection:
30 Vdc will cause siren output to cease, resume at normal.
Low Voltage Shutdown:
Voltage below 9.0 Volts for 10 seconds or more will cause siren output
to cease and will resume when system voltage is above 9.0 Volts
Operating
Temperature / Humidity:
-40° F to +110°F temperature, 5-95% Non-condensing humidity
Controls:
Tone, Yelp, Wail, Horn, Manual, Horn Ring,
Park Kill, Ignition, PA, Radio Rebroadcast
Boxed Weight
3 Lbs.
INPUT WIRE HARNESS
WIRE COLOR:
FUNCTION
ACTIVATION METHOD
TAN
Tone 1 Select
Connect to +Vdc
BROWN
Tone 2 Select
Connect to +Vdc
TAN AND
BROWN
Tone 3 Select
Connect to +Vdc
RED/BLACK
Manual Tone Select
Connect to +Vdc
RED
Horn Tone Select
Connect to +Vdc
ORANGE/BLACK
Ignition Input
Connect to +Vdc
WHITE/RED
PA Audio through Siren Connect PTT Switch wire (Grey) to ground (-)
BLUE
Radio Rebroadcast
Connect Grey wire to +Vdc
YELLOW
Park Kill / Tone Disable
Connect to Ground (-)
WHITE
Horn Ring Output
WHITE/BLACK
Horn Ring Input
Ground Input Signal
VIOLET
Tone / Volume Program
Connect to Ground to change tone / volume
HORN RING TONE ACTIVATION:
When Horn Ring is activated, while Tone 1 is activated,
the siren will switch to Tone 2 for 5 seconds and then
return to Tone 1
When Horn Ring is activated, while Tone 2 is activated,
the siren will switch to Tone 1 for 5 seconds and then
return to Tone 2
When Horn Ring is activated, while Tone 3 is activated,
the siren will switch to Tone 1 for 5 seconds and then
return to Tone 3
HANDS FREE OPERATION:
When the Horn Ring is programmed to a warning tone,
Hands-free operation is enabled. When the Horn Ring
is activated, the tone will sound until the Horn Ring is
activated again. Tone1, Tone2, Tone3, PTT, Manual Tone
and Radio Rebroadcast will override Hands-free operation.
PA VOLUME PROGRAMMING
1. Connect audio source to White/Red wire
2. Connect Grey wire to ground to activate PA
3. Momentarily connect Violet wire to ground to toggle
through the available volume settings.
4. The last volume selected will be programmed to be
used whenever PA control is selected
ETSA2ØØR
RADIO RE-BROADCAST VOLUME
PROGRAMMING
5. Connect audio source to Blue wires
6. Connect Grey wire to +V to activate Radio Rebroadcast
7. Momentarily connect Violet wire to ground to toggle
through the available volume settings.
8. The last volume selected will be programmed to be used
whenever Radio Rebroadcast is selected
