TONE SELECT PROGRAMMING
1. Connect the following wires to +Vdc to activate tone that needs to be programmed
2. Momentarily connect Violet wire to ground to toggle through available tones
3. The last tone selected will be programmed to be used whenever selected control wires
are activated
4. Repeat steps 1-3 for each tone option
NOTE: Manual Function is NOT programmable.
TONE RESET INSTRUCTION:
When toggling through available tones, holding the violet wire to ground for more
than two seconds the tone will switch to the default tone.
(See Horn Tone and Warning Tone Table below)
ETSA2ØØR 5.13
SPEAKER CONFIGURATION
WHITE/RED JUMPER WIRE
SINGLE 100 WATT SPEAKER
DO NOT CUT
SINGLE 58 WATT SPEAKER
Cut and Tape both ends
DUAL 58 WATT SPEAKER
Cut and Tape both ends
INSTALLATION:
1. Mount Amplifier Assembly in a protected location, being careful to route wires away from
any hot surfaces or areas where the wires may get pinched.
2. Locate Green and Green/Black wires that are on opposite corners of all other input/control
wires. These are the outputs to the speaker(s)
3. Connect these 2 wires to the speaker(s) which are installed on the vehicle. The white/
red wire jumper will determine if the amplifier is to operate at an output voltage designed
to drive a single 100 Watt speaker or a single/dual 58 Watt speaker(s). See electrical
schematic on reverse side for more information.
4. Connect Black wire to reliable ground. Using wire capacity chart as a guideline to
establish wire gauge to use for extending wires.
5. Connect Orange wire to fused coVdc. Using wire capacity chart as a guideline to
establish wire gauge to use for extending wires.
6. Connect Orange/Black wire to ignition switch. +Vdc is required on Orange/Black wire for
siren to operate.
7. Connect Tone 1, Tone 2, Manual Tone, Horn Tone wires to provided switch panel as
needed.
8. Program Tones following instructions found earlier in the manual under Tone Select
Programming.
9. Connect Blue wires to radio output if radio rebroadcast feature is required.
10. Connect White/Red wire to PA microphone.
11. Connect PTT / Radio Rebroadcast activation wire and to switch that will supply ground
when activated for PA function and +Vdc when activated for Radio Rebroadcast function.
A Single Pole Double Throw (SPDT) switch with center OFF position will be required for
this.
12. Program Radio Rebroadcast following the Programming instructions found earlier in the
manual under Radio Re-broadcast Volume Programming.
13. Program Radio Rebroadcast following the Programming instructions found earlier in the
manual under PA Volume Programming.
14. (OPTIONAL) Attach Yellow wire (Park Kill) to a switch that will supply ground whenever
the siren is to be disabled.
WIRE COLOR:
FUNCTION
TAN
Tone 1 Select
BROWN
Tone 2 Select
TAN AND BROWN
Tone 3 Select
RED
Horn Tone Select
WHITE/BLACK
Horn Ring
HORN TONE TABLE
HORN TONE 1
Default
HORN TONE 2
HORN TONE 3
HORN TONE 4
ETSA2ØØR
WARNING TONE TABLE
WAIL
Tone 1 and Horn Ring
(default)
YELP
Tone 2 (default)
ALERT A
Tone 3 (default)
PIERCER
Hi-Lo
SUPER Hi-Lo
CYCLE TONE
Plays thru Wail, Yelp, Alert
A and Piercer (Tone changes
every 5 seconds)
