Soundigital 3000.1 EVO 5 1, Owner'S Manual

Page: 8 / 14

POWER CABLE
GROUND CABLE
SPEAKER CABLE
3000
WRMS
35mm² - 2 AWG
2 x 6.0mm² - 9 AWG @ 1 Ω
2 x 4.0mm² - 11 AWG @ 2 Ω
2 x 2.5mm² - 13 AWG @ 4 Ω
High Level input
RCA AND HIGH INPUTS SHOULD NOT BE USED SIMULTANEOUSLY OR YOU MAY
DAMAGE THE AMPLIFIER.
Warning!
All RCA Inputs must be connected for the
all channels to work properly. If the signal
source is mono type, use "Y" cable at the
input.
8
AUDIO INPUTS
RCA inputs
For proper operation of your SounDigital amplifier, you need the proper
dimensioning of the electrical system and the cables used.
The table below shows the minimum section of GND cables, +12VDC cables and
speaker output cables according to the power generated by the amplifier.
ELECTRICAL DIMENSIONING AND AUDIO INPUTS
ELECTRICAL DIMENSIONING
We recommend the use of ONLY OFC (Oxygen Free Copper) Cables on the
installation of our products. CCA cables must not be used.
All High Level Inputs must be connected
for the all channels to work properly.
High level input must be used when the main unit does not have RCA outputs.
When High level inputs is used, no remote connection is required, the amplifier
recognizes the audio signal and switches on.
If your source unit is not able to turn on the amplifier through the High level input,
the remote input should be connected normally.