Installation
Left switch
ÏDOWNÓ
CD-MP3 Emulation Mode Selection (CD-MP3 emulation)
CD-MP3 Emulation Mode programming steps:
Properly install this unit.
Put “Left” programming switch in “DOWN” position.
Put ignition switch into the “ACC” position.
Wait for long beep followed by a few short beeps. This may take up to one minute.
LEXPD2
Put ignition switch into the “OFF” position.
Ignition into
ÏACCÓor ÏONÓ
position
Ignition into
ÏOFFÓposition
Both switches
ÏUPÓ
Ignition into
ÏACCÓor ÏONÓ
position
Wait 10 sec
Wait for long beep
Carpet or car chassis
“Soft” Velcro Fastener
“Hard” Velcro Fastener
Mounting unit using Velcro fasteners
Velcro Fasteners are not included
SoundGate strongly recommends grounding the unit to the car chassis for best results.
NOTE
M4 x 5mm*
(see note below)
7