20
USER GUIDE
USER GUIDE
USER GUIDE
USER GUIDE
USER GUIDE
7
FADER
The 100mm FADER gives you smooth control of the overall signal level in the channel
strip, allowing precise balancing of the various source signals being mixed to the Master
Section. It is important that the input level is set correctly to give maximum travel on the
fader which should normally be used at around the “0” mark. See the “Initial Setup”
section on page 23 for help in setting the right level.
8
SOLO
When the latching SOLO switch is pressed, the pre-fade pre-mute signal is fed in mono
to the headphones, control room output and meters, where it replaces the MIX. The
SOLO LED on the Master section illuminates to warn that a SOLO is active. The Left and
Right meters display the SOLO signal in mono. This is a useful way of listening to any
required input signal without interrupting the main mix, for making adjustments or tracing
problems.
9
CHANNEL PEAK LED
This LED will light when the signal level approaches clipping at any of the three moni-
tored points:
a) PRE-EQ
b) POST-EQ
c) POST-FADE
7
1
2
3
4
5
6
8
9
