www.soundskulptor.com
Document revision 1.1 – Last modification : 27/05/21
EQ573 Assembly guide – Final assembly
32. Front panel assembly
Insert and attach the front panel with three M2.5x8mm black screws.
33. Chassis plate assembly
Attach the chassis plate to the front plate with two M3x6mm black screws.
34. Main PCB assembly
Insert the main PCB connectors into the switch PCB connectors.
Screw four nuts to the four M3x25mm spacers and use them to attach the main PCB to the chassis
35. 19mm red knobs
Set all the rotary switches fully anti-clockwise.
Place the three 19 mm red knobs on the three top switches, lining up the white lines to the “off” labels.
Tighten very gently the screws with the supplied 1.5mm hex key.
Warning
: To not tighten too hard in order not to warp the switch shaft.
36. 12.7mm buttons
Set all the potentiometers to 12 o'clock. You must feel the centre click in this position.
Insert the three 12.7mm black knobs into the three top switches, lining the white lines vertically.
Tighten the two screws with the supplied 1.5mm hex key.
Attach the last knob to the lowest rotary (high pass), lining up the white line to the “off” label.
37. Cover
Attach the cover with 4 M3x6mm countersunk screws.
38. Congratulations
You're done!
Copyright ©2020 to today SoundSkulptor
