Sound Devices SL-6, User Manual

Page: 15 / 20

15
SL-6 POWERING AND WIRELESS SYSTEM
s
creen
e
leMent
D
escription
Antenna phase The antenna icon is displayed when Switching Diversity mode
is active on the receiver. Icon will flip vertically when antenna
phase is inverted.
Transmitter battery level Displays the level of the transmitter’s battery. The transmitter
battery level is indicated by the color of the battery icon and the
level of the bar. Green = over 50%, Yellow = over 20%, Orange
= over 10%, Red = less than 10%. When the transmitter battery
level information is not supported, the icon is black.
i
This information is only provided when supported and supplied by
the transmitter.
Compatibility Displays the current compatibility mode of the receiver.
To cycle through compatibility modes:
X
Slide MIC/TONE switch left or right.
688 channel information Displays the name and number of the 688 channel to which the
receiver is routed.
Pre-fade level Displays pre-fade audio level of the receiver’s output on the 688
input to which it is routed.
Frequency Displays the frequency to which the receiver is currently tuned.
Whole number and decimal number are adjusted independently.
Decimal adjustments in .1 (Normal tuning) or .025 increments
(Fine tuning).
To adjust frequency:
X
Turn and press Headphone encoder.
Block & Tx Switch Displays the block number and transmitter switch value.
Tuning Displays current tuning group. When adjusting frequency, values
will be restricted to the selected tuning group.
“Fine” sets increment to .025, and “Normal” sets increment to .1
To cycle through tuning groups:
X
Slide RTN/FAV switch left.
Menu Accesses the receiver’s model-specific settings. Slide RTN/FAV
switch to access menu.
To access receiver’s settings:
X
Slide RTN/FAV switch right.
Receiver Details Screen - Example B
The following example of the Receiver Details screen is for a Wisycom MCR42.
Refer to Wisycom documentation for further explanation of these settings.
i
This section applies to Wisycom receivers with firmware version 3.5 or later. Wisy -
com receivers with earlier versions of firmware will be treated as unislot receivers;
therefore, the Receiver Details screen will not be accessible.