71
Setup Menu Shortcuts
The setup menu can quickly be navigated by using the Rotary Switch to scroll up and down through
the menu. Additionally, shortcuts, or “breadcrumbs” can be placed on often-used menu items. A
breadcrumb is set by holding the play key. A small dot is shown to the left of the setup number. Any
number of breadcrumbs can be set, but their utility is reduced with too many applied.
toggles among menu breadcrumbs to
higher numbered items
with no breadcrumbs placed, moves to
the next general menu section
press and hold to set or remove a menu crumb;
single press navigates to menu item #1
toggles among menu breadcrumbs to
lower numbered items
with no breadcrumbs placed, moves to
a previous general menu section
CL-1 Remote Control and Keyboard Interface
The CL-1 Remote Control and Keyboard Interface is an available hardware accessory to interface
computer keyboards and enable external devices to control the 744T. When using the CL-1, front
panel controls and menu selections on the 744T can be mapped to keyboard shortcuts, allowing
for full keyboard control of the recorder. Additionally the CL-1 has electrical contacts that can be
programmed as inputs or outputs. A common use for the remote inputs is for machine control and
“remote rolling” using a mixing console with transport controls.
Connecting the CL-1
1. Connect the included C. Link cable to the 744T’s C. Link Input connector.
2. Connect the opposite end of the C. Link cable to the CL-1’s C. Link connector.
3. Connect a PS/2 keyboard to the PS/2 connector on the CL-1.
4. Connect switches between assigned pins 1-7 and pin-8 (ground) on the CL-1.
The C. Link port on the 744T provides power for CL-1 operation.
Keyboard Assignments
Numerous standard keys and key combinations on attached keyboards are pre-assigned. The chart
below shows the operation of these pre-assigned keys.
Summary of Contents for 774T
Page 2: ...backside front cover ...
Page 81: ...79 ...
Page 82: ...702 rev 2 09 Printed in U S A ...
