After connecting all of the component systems, turning on the relevant equipment and equipping the remote
control with the batteries, the user is now ready to use the DVD video player.
Preparation
a. Turn on the TV set.
b. If
amplifier is connected, you should turn on the
an
amplifier and
select the corresponding mode of the amplifier according to your
DVD video player.
c. Turn on the player.
1. Press the POWER button of the DVD video player to
turn on the player.
Switch the input mode of the TV to either VIDEO IN or Channel 3 or
4 (depending on the Model of the TV).
2. Press the OPEN/CLOSE button on the player or remote
control to eject the disc tray.
a. After the disc tray is ejected, insert a disc with label side upward into
the disc tray.
3. Alternatively Press PLAY
The player recognizes the format of the disc automatically, and the
result will appear on the display screen of the player. Then the player
will automatically play the program. If the menu or selection menu
appears, use buttons on the remote control to select the
desired program. Then press ENTER to play the selected program,
or press the number buttons to select the program directly.
Basic Play
/ / /
b. For all discs, simply press desired track number, and drawer
will close and the selected track will play. If the disc is a DVD movie,
simply closing the drawer will cause the player to begin to play the movie
at the beginning of Chapter 1 or the start of the movie.
11
Notes:
1. During playback, if the picture is not in full-screen, or the edge is
covered, or there is no picture, you must change the video output
setting to the local corresponding TV signal format: PAL or NTSC.
2.
When a appears on the TV
screen, it indicates that the operation
is invalid or can`t be accepted by the player. This is controlled largely
by the programming on the DVD disc; therefore, it will vary from DVD
to DVD.
3
2
1
