© 1996-2021 SOTA Instruments Inc.
Page 11 of 12
|
www.sota.com
The Silver Pulser Model ZBB2 Manual
Switch Silver Wire Positions - Silver Wire Holder Option: The silver ions only
come off the wire in the positive (+) or anode terminal into the water. To equalize the
wearing of the Silver Wires, periodically exchange the position of the wires. If left in
the same position, only one Silver Wire will gradually wear away.
Replacing the Silver Wires: The Silver Wires are of the highest grade .9999 or 99.99%
or 4 Nine pure fine silver. When the SOTA pure Silver Wires wear too thin, do not
replace with sterling silver, as it contains nickel, which can be toxic.
TYPICAL USE
Quantity:
There is no definite amount to drink. When consumed on a regular basis—
daily or several times a week—it is best to drink no more than 1 to 2 ounces (30 to 60
ml) at a time.
Larger amounts of Ionic~Colloidal Silver—1 cup or more—can be consumed for
short periods of time, for example, a few weeks. It is better to take smaller amounts
throughout the day rather than all at once.
Length of Use: The SOTA Products User Guide available at
www.sota.com/spug offers suggestions for Focused, Basic and Ongoing Wellness
Plans.
General Guideline: 1 to 2 ounces (30 to 60 ml) or more daily for 2 or 3 months.
Ionic~Colloidal Silver can be used as needed. The initial program can be repeated at
any time. If using for an extended period, it is wise to take breaks.
Strength: Laboratory testing indicates Ionic~Colloidal Silver is effective as low as 2
ppm. When ingesting on a regular basis, it is suggested to limit the strength to less
than 10 ppm.
ELECTRICAL SPECIFICATIONS
POWER REQUIREMENTS
Use a 9–Volt Alkaline battery for proper operation.
OPTIONAL POWER INPUT
Both functions of the Silver Pulser can also be operated using NiMH rechargeable
batteries. When purchasing rechargeable batteries, it is suggested to take the unit
with you to ensure the batteries will fit the enclosure.
To use a wall adaptor for making Ionic~Colloidal Silver the output should be from
6 to 12 Volts DC with a Tip or Center Positive pin and a minimum of 500 mA
