© 1996-2021 SOTA Instruments Inc.
Page 6 of 14
|
www.sota.com
The Silver Pulser Model ZBB1 Manual
WHITE: Indicates impurities in the water or that the wires are touching when making
Ionic~Colloidal Silver.
HOW TO USE THE MICROPULSING FUNCTION
1. Place the 9-Volt Alkaline battery in the unit.
a. On the back of the unit, slide off the
battery cover.
b. Attach the positive (+) and negative (-)
terminals on the 9-Volt Alkaline battery
to the positive (+) and negative (-) clips in
the battery compartment.
c. Slide the 9-Volt Alkaline battery into the
case and push down. Slide the cover back
onto the unit.
2. Clean the wrist area to remove oils from the
skin. This will allow for better conductivity.
3. Insert the Micropulsing cord into the jack
on the unit.
4. Place the unit in a pocket.
Option: If preferred, the unit can be placed in an arm strap and held in place on the
arm. A short probe cord is best for this option.
ALL COTTON SLEEVES OPTION
5. Prepare one pair of Cotton Sleeves. Each Cotton Sleeve is
sewn on three sides; to find the open end of the Cotton
Sleeve, squeeze the long sides of the sleeve and the
unsewn end will pop open.
6. Insert one probe from the Micropulsing Cord into the
open end of each Cotton Sleeve. Use a gentle twisting
motion to work the probes into the Cotton Sleeves.
7. Wet the Cotton Sleeves with water.
8. Put the Wrist Strap on.
1
