Page 19 / 22
Assembly instructions
Compact-Line kit
www.sorotec.de
V 2.1.0
Assembly Z axis
Fig. 22: Completely assembled Z-axis on the mechanically fully assembled Compact-Line
• Drive the cylindrical pins
Z
into the guide
plate Z
11
until they protrude by about
3 ... 4 mm.
• Screw the carriage
14
to the guide plate with
cylinder screws M5x16
C2
The following must
be observed:
-ground, blank surface on the long sides of
the carriage point to the outer edges of the
plate
-The lubricating nipples on the carriages point
outwards. If necessary, turn the lubricating
nipples or screw them to the opposite end
• Slightly counter-tighten the screws
• Slide the linear rail
18
into the two carriages
as shown in Figure 23. Press the carriage with
the linear rail against the cylindrical pins and
screw the two carriages tight in this position.
Tightening torque: 6 Nm
• Remove cylindrical pins (were only required for
alignment during assembly).
• Degrease the adhesive surface and stick a
rubber pad
12
to the guide plate Z.
Note
The fastening screws of the carriages
are only tightened during alignment.
Fig. 23: Assembly of the carriages
14
14
Z
C2
C2
Z
14
11
12