16 von 36
Service record Dynamis MV
Service record Dynamis MV
2021-01-12
3.4
Back assembly
3.4.1 Setting dynamic back
The back dynamics of the Dynamis TSD can be adjusted with the included SORG open-end
wrench (1).
Please note the following steps:
1.
Increase
the counterforce
(2)
: Turn the adjusting nut to the
right
with the help of the SORG
open-end wrench. This increases the dynamism of the back.
2.
Reduce
the counterforce
(3)
: Turn the adjusting nut to the
left
with the help of the SORG
open-end wrench. This weakens the dynamic of the back.
The nut must always be screwed in at least so far that the steel spring is slightly pretensi-
oned.
(1)
(2)
(3)
3.4.2 Adjustment of the back angle
The basic setting of the back ang-
le can be changed via the row of holes
in the suspension of the spring damping.
The setting can be changed to 90 °, 95 °
and 100 ° from the inside to the outside.
For this purpose, the screw
(A)
- in this picture in
the setting 90 ° - is loosened and fastened again
with the spring damper in an outer hole
(B)
. Ple-
ase tighten the screw, but not too tight, so that the
spring remains flexible.
(A)
(B)
(1)
