INSTALLATION
°CALEON Installation
Mount the unit at a suitable location.
Pay attention to suitable environmental conditions.
Direct sunlight, sources of heat and cold, e.g. radi-
ators and windows must be avoided.
Strip cables, slip protective conductor over and remove fill
material as needed.
When mounting °CALEON's base to the wall the connecting
cables must be kept as short as possible. For direct wall
mounting a maximum length of 40 mm is recommend. Long
wire loops inside the °CALEON's housing may cause prob-
lems.
When mounting °CALEON's base to a plastic wall socket the
connecting cables must be kept as short as possible (strip
cables not more than 55 mm). Also make sure that wire loops
are led back to the plastic wall socket, since long wire loops
inside the °CALEON's housing may cause problems.
Strip the last 8 - 9 mm of the wires. Isolate shielding and con-
nect it at a suitable location (controller or CAN-box) to the pro-
tective conductor.
Any contact between protective conductor and cir-
cuit board can cause serious damage.
Mounting on plastic wall socket
Fix the base with the screws (3,0 x 16) to the mounting box.
Direct wall mounting
Hold the lower part of the housing up to the selected position
and mark the three mounting holes. Make sure that the wall
surface is as even as possible so that the housing does not
become distorted when screwed on. Using a drill and drill
holes at the points marked on the wall and push in the plugs.
Insert screws and screw it in slightly. Align the base and
tighten the screws.
Open the terminals with the accompanying operating tool and
make the electrical connection as described.
Power supply 24 VDC, ensure correct polarity or it
may cause damage to the unit!
6
