SAFETY INSTRUCTIONS
EG-Conformity
By affixing the CE mark to the unit the manufacturer declares that °CALEON Smart conforms to the following relevant safety reg-
ulations:
l
EU low voltage directive 2014/35/EU
l
EU electromagnetic compatibility directive 2014/30/EU
conforms. Conformity has been verified and the corresponding documentation and the EU declaration of conformity are kept on file by
the manufacturer.
General Instructions
Please read carefully!
These installation and operating instructions contain basic instructions and important information regarding safety, installation, com-
missioning, maintenance and the optimal use of the unit. Therefore these instructions must be read and understood completely by the
installation
technician/specialist and by the system user before installation, commissioning and operation of the unit.
This unit is an automatic, electrical °CALEON Room Controllers. Install the unit only in dry areas and under the ambient conditions
described in “Specifications”.
This document contains information specific to the ZWave Plus technology implemented at ° CALEON in order to ensure correct
interoperability between third-party devices.
In addition, observe the applicable accident prevention regulations, the regulations of the Association of Electrical Engineering, the
local power supply utility, the applicable DIN-EN standards and the installation and operating instructions for the additional system
components. Installation, electrical connection, commissioning and maintenance of the device may only be carried out by an appro-
priately trained specialist.
Users: Make sure that the specialist gives you detailed information on the function and operation of the unit. Always keep
these instructions in the vicinity of the unit.
The manufacturer does not take over any liability for damage caused through improper usage or non-compliance of this manual!
Before working on the unit, switch off the power supply and secure it against being switched on again! Check that there is
no power flowing! Electrical connections may only be made by a specialist and in compliance with the applicable reg-
ulations. The unit may not be put into operation if there is visible damage to the housing, e.g. cracks.
Changes to the Unit
l
Changes, additions to or conversion of the unit are not permitted without written permission from the manufacturer.
l
It is likewise forbidden to install additional components that have not been tested together with the unit.
l
If it becomes clear that safe operation of the unit is no longer possible, for example because of damage to the hous-
ing, turn the Unit off immediately.
l
Any parts of the unit or accessories that are not in perfect condition must be exchanged immediately.
l
Use only original spare parts and accessories from the manufacturer.
l
Markings made on the unit at the factory must not be altered, removed or made illegible.
l
Only the settings described in these instructions may be set using the Unit.
Changes to the unit can compromise the safety and function of the unit or the entire system.
3
