Sony XDCAM PDW-HR1, Operation Manual, Page: 130 / 214

130
File Operations in File Access Mode (for Windows)
Chapt
er
7
F
ile Op
er
at
ions
File Operations in File
Access Mode (for
Windows)
File access mode operating environment
Operating system requirements for file operations by file
access mode (called FAM below) are as follows.
• Computer operating system: Microsoft Windows XP
Professional SP3 or higher, Microsoft Windows Vista
Business/Ultimate (32 bit/64 bit) SP2 or higher, or
Microsoft Windows 7 Professional/Ultimate (32 bit/64
bit)
Preparations
Install the FAM driver on the remote computer.
To install the FAM driver
Download the FAM driver and install it on the remote
computer.
For details about downloading the FAM driver, see
“Software Downloads” (page 190).
Use Version 2.10 or higher of the FAM driver.
If a FAM driver is already installed on your computer,
check the version.
To check the version
For Windows XP:
Select “ProDisc” from “Add or Remove Programs” in the
control panel, and then click “Click here for support
information”.
For Windows Vista:
(1) Open “Programs” >“Programs and Functions” in the
control panel, and then right click the header (where
“Name” and “Supplier” are displayed) and select
“Other...”.
(2) In the Advanced Settings dialog, check “Version” and
click “OK”. The version column appears. Check the
version of “ProDisc”.
For Windows 7:
Open “Programs and Features” in the control panel, and
then check the version of “ProDisc”.
Making FAM connections
1
If there is a disc loaded in this unit, put the unit into the
following state.
• Recording, playback, search and other disc
operations (see page 62) : Stopped
• THUMBNAIL/ESSENCE MARK button (see
page 24) : Off
• Disc access by Lock or Delete All Clips, Format
Disc, and so on in the Disc Menu (see page 77) :
Stopped
• Unsaved current clip list: Save or clear
2
If this unit is connected to a remote computer by FTP,
log out from the FTP session
(see page 134) .
3
Connect the (i.LINK) S400 FAM connector on this
unit to the i.LINK (IEEE1394) connector on the
remote computer, using an i.LINK cable
(see
connections illustration on page 44) .
4
Press the PC REMOTE button, lighting it. (This
enables remote access
(see page 23) .)
Windows recognizes this unit as a removable disc, and
displays one of the following icons on the remote
computer’s task bar:
• Windows XP:
• Windows Vista or Windows 7:
The remote computer is now able to perform file
operations when a disc is inserted into this unit.
You will not be able to log in if you put the unit into
the state described in step
1 after connecting the cable.
To log in, press the PC REMOTE button, turning it off,
put the unit into the state described in step
1 , and
connect it again.
When you make your first FAM connection
The Found New Hardware Wizard dialog appears when
you connect this unit to your computer. Select “Install the
software automatically (Recommended)”, and then click
the Next button. Click the Finish button when the software
installation finishes.
Operation limitations during FAM connections
• Control panel operations are disabled, except for
operations with the EJECT button.
• This unit cannot be controlled from devices connected to
the REMOTE(9P) connector (D-sub 9-pin) and
(i.LINK) S400 FAM connector.
• Signal input to this unit and signal output from this unit
are stopped.
Note
Note