30
XCG-CP510/XPL-SDKW
2020
XCL
XCG
Digital V
ideo Camera (GS
CMOS)
Digital V
ideo Camera (CCD)
Accessories
XCL
XCU
Color Camera Block
FCB-4K
FCB-HD
Polarization
Camera
a
b
Relative sensitivity
• XCG-CP510
0.0
0.2
0.4
0.6
0.8
1.0
400
600
800
500
700
900
Wavelength (nm)
(Lens characteristics and light source characteristics excluded.)
Spectral Sensitivity Characteristics
1
Lens mount (C-mount)
Attach any C-mount lens or other optical equipment.
Use a C-mount lens with a protrusion (a) extending from the lens
mount face (b) of 10 mm (13/32 inch) or less.
2
Guide screw holes (Top)
3
Guide screw holes/Tripod screw holes (bottom)
When using a tripod, use these four screw holes to attach
a VCT-333I tripod adaptor.
4
Reference screw holes (bottom
)
These precision screw holes are for locking the camera
module. Locking the camera module into these holes
secures the optical axis alignment.
Location and Function of Parts and Controls
Note
1
2
3
4
6
RJ45 connector
You can connect a LAN cable to this connector to control the
camera module from a host device to output image to a host
device. By using a PoE-compatible LAN cable and camera
module interface board or hub, you can supply power using the
LAN cable.
For safety, do not connect the connector for peripheral device
wiring that might have excessive voltage to this port.
7
Reset switch
The camera can be reset to the factory setting by pressing the
reset switch for more than 3 seconds while the power is turned
on.
8
Status LED (Green)
This button is lit when power is being supplied to the camera.
Various settings linked with GPO are available, such as to light
up when interlocking with the trigger signal.
This button blinks when the network is disconnected, or while 1P
is being acquired.
Pin No.
Signal
Pin No.
Signal
1
DC input
(10.5 V to 15 V)
4
GPI3/GPO3
(GPO3 (ISO +)*)
2
GPI1 (ISO +)
5
GPI1 (ISO –)
3
GPI2/GPO2
6
GND
* only XCG-CG160/CG160C
5
DC IN (DC power input) connector (6-pin)
You can connect a camera cable to input the +12 V DC power
supply. The pin configuration of this connector is as follows.
(Refer to Fig. 6 above for the pin assignment of the
connector.)
Rear Panel/Pin Assignments
6
5
7
8
Note
