XAV-68BT
3
SECTION 1
SERVICING NOTES
NOTES ON HANDLING THE OPTICAL PICK-UP
BLOCK OR BASE UNIT
The laser diode in the optical pick-up block may suffer electro-
static break-down because of the potential difference generated by
the charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The
fl
exible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused
on the disc re
fl
ective surface by the objective lens in the optical
pickup block. Therefore, when checking the laser diode emission,
observe from more than 30 cm away from the objective lens.
Label indication
Destination
Signal format
system
Region
code
Part No.
NTSC
1
4-540-917-0
[]
US and Canadian
models
NTSC
4
4-540-918-0
[]
E (NTSC) model
PAL
3
4-540-919-0
[]
E (PAL) model
PAL
5
4-540-921-0
[]
Indian model
PAL
5
4-540-922-0
[]
Russian model
PAL
2
4-558-481-0
[]
Saudi Arabia model
PAL
4
4-558-482-0
[]
Australian model
PAL
2
4-564-299-0
[]
AEP and UK
models
MODEL IDENTIFICATION
Part No.
Region Code
(US and Canadian models)
– Bottom View –
(US, Canadian, AEP, Russian, UK,
E (PAL) and Saudi Arabia models)
Region Code
(Russian model)
Region Code
(E (PAL) and
Saudi Arabia models)
Part No.
Region Code
– Bottom View –
(E (NTSC), Indian and Australian models)
Region Code
(AEP and UK models)
IMPORTANT NOTE FOR REPAIRING
XAV-68BT contain individual information that the customer regis-
tered because it installs the Bluetooth function.
When repairing, the data that the customer registered might disap-
pear. Have the approval of the customer beforehand.
If any of the following repair is performed, that data disappears.
• Complete BT board replacing
• Initialize
Note:
Replaced old complete BT board is destroyed with the hammer,
and throw out it.
ABOUT THE SECURITY FUNCTION
This unit does not use security function by password lock.
ABOUT THE REPAIRING OF BOARD
When each boards installed on this unit are defective, replace the
parts including the board or complete mounted board.
However, only the following IC can replace with single.
Ref. No. Part No.
Description
Remark
U308
9-885-201-53 IC LM1117-ADJ
– MAIN Board (Top view) –
U308
Under normal conditions, the battery will last
approximately 1 year. (The service life may be
shorter, depending on the conditions of use.)
When the battery becomes weak, the range of the
remote commander becomes shorter. Replace the
battery with a new CR2025 lithium battery. Use of
any other battery may present a risk of fire or
explosion.
Notes on the lithium battery
Keep the lithium battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.
Wipe the battery with a dry cloth to assure a good
contact.
Be sure to observe the correct polarity when installing
the battery.
Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of in
fire.
REPLACING THE LITHIUM BATTERY OF THE REMOTE
COMMANDER
Ver. 1.3
