13
⁄
AC IN
REMOTE (15PIN)
ANTENNA A
DO 9V OUT
IN
ANTENNA B
DO 9V OUT
IN
1
2
TUNER OUTPUT
Rear Panel
1
ANTENNA A, B IN / DC 9 V OUT connectors
2
TUNER OUTPUT connectors
3
REMOTE connector
4
AC power output connector
5
AC IN connector
1
ANTENNA A, B IN / DC 9 V OUT (antenna A, B
input/DC power output) connectors (BNC type)
Connects to an AN-820A UHF Antenna (A/B) for
diversity reception.
If an antenna is connected directly to the tuner without
connecting with an antenna divider such as the WD-
820A, DC 9 V is supplied to the antenna’s internal
booster.
Note
Never short-circuit this connector.
2
TUNER OUTPUT (tuner sound output)
connectors (XLR, 3-pin, male)
Supplies audio signals. You can connect this to the
microphone input connector or the sound input
connector of a mixer, tape recorder, or similar
equipment.
3
REMOTE connector (D-sub, 15-pin)
Connects to a display unit (not supplied) that shows
the numbers for 12 channels and is equipped with an
AF lamp and an RF lamp.
4
AC power output connector
Supplies a maximum of 300 W power to a peripheral
piece of equipment, regardless of whether the POWER
switch is set to ON or OFF.
5
AC IN connector
Connects to an AC power source with the supplied AC
power cable.
1
3
2
1: GND
2: HOT
3: COLD