Sony WEGA KP-FX43, Operating Instructions Manual

Page: 50 / 340

50
Additional Information
Troubleshooting (continued)
• Check the power cord, antenna and
the VCR connections.
• Press I / 1 on the remote.
• Press ! on the projection TV to turn
off the projection TV for about five
seconds, then turn it on again.
• Press 2 + to increase the volume
level.
• Press % to cancel the muting.
• Press A/B until a better sound is
heard.
• Press or .
• Do not use a hair dryer or other
equipment near the projection TV.
• Adjust the antenna direction for
minimum interference. Contact a
Sony dealer for advice.
• Use a highly directional antenna.
• Use the fine tuning (“FINE”) function.
• Adjust the antenna direction. Contact
a Sony dealer for advice.
• Turn off or disconnect the booster if it
is in use.
• Display the “PICTURE” menu and select
“ADJUST” of “PICTURE MODE”, then
adjust the “COLOR” level.
• Display the “SETUP” menu and
check the color system (“COL SYS”)
setting (usually set this to “AUTO”).
• Adjust the antenna direction. Contact
a Sony dealer for advice.
No picture
No sound
Good picture
No sound
Dotted lines or
stripes
Double images or
“ghosts”
No color
• The power cord, antenna
or VCR is not connected.
• The projection TV is not
turned on.
• The volume level is too
low.
• The sound is muted.
• The broadcast signal
has a transmission
problem.
• The sound of the right
picture is selected
when TWIN pictures
are displayed.
• There is local
interference from cars,
neon signs, hair dryers,
power generators, etc.
• Broadcast signals are
reflected by nearby
mountains or buildings.
• The antenna direction
needs adjustment.
• Use of a booster is
inappropriate.
• The color level setting
is too low.
• The color system
setting is
inappropriate.
• The antenna direction
needs adjustment.
Possible cause
Symptom
Solutions
Page
6
15
16
16
16
26
21
–
–
–
46
–
–
38
43
–