Recording
Recording
23
EN
Recording from audio equipment with
digital output (Digital connection)
1
Use and connect the optical cable or coaxial cable
according to the digital output jack of the
connected equipment.
2
Set the INPUT SELECT switch of the connecting
cable to DIGITAL.
3
Press the
r
REC and
P
PAUSE buttons.
4
Press either the
(
PLAY or
P
PAUSE button to
begin recording. Then, begin playback of the
connected source.
Source and sampling frequency for recording
When recording with digital connection, the sources
will be automatically recorded in its own sampling
frequency shown below.
Source
Sampling frequency
Broadcasting satellite B mode
48 kHz
audio
DAT SP mode
CD
44.1 kHz
MD
DAT SP mode
Broadcasting satellite A mode
32 kHz
audio
DAT LP mode
Notes
• If “
”
is displayed, the source
cannot be recorded.
(See page 38)
• Use only the
recommended digital
cable (not supplied).
(see page 47)
You cannot use the
POC-DA12/DA12M/
DA12S or RK-DA10
digital connecting
cables with this unit.
• Make sure to set the
INPUT SELECT switch
of the connecting cable
to DIGITAL before
recording. Switching it
during recording will
cause a short mute in
the recording.
Tips
In digital connection, note
the following:
• Setting the recording
mode is not required.
• The recording level is
set automatically to the
level of the source.
Manual adjustment is
not available in this
case.
• Setting of the SP•LP
switch is applicable
when recording a 32
kHz source only.
(When set to SP, the
source is recorded in
the 32 kHz SP mode.
When set to LP, the
source is recorded in
the 32 kHz LP mode.)
Other sources will be
automatically recorded
in its own sampling
frequency regardless of
the SP•LP switch. In
this case, you cannot
record in the LP mode.
to REMOTE
DIGITAL I/O
Coaxial cable
RK-DA10P
(not supplied)
Optical cable
POC-DA12P
POC-DA12MP
POC-DA12SP
(not supplied)
INPUT
SELECT
to (OPTICAL)
digital output
CD player,
BS tuner,
DAT deck,
etc.
to (COAXIAL)
digital output
or
TCD-D100
