63
Oth
e
rs
On-screen display
Remote control
The picture is too dark.
c
Adjust the “Contrast” or “Brightness” of the Picture
menu
properly. (
1
The picture is not clear.
c
Adjust the focus. (
1
page 18)
c
Condensation has accumulated on the lens. Leave the projector
for about 2 hours with the power on.
The picture flickers.
c
For pictures from a computer, activate “APA” and adjust the
current input signal.
c
Adjust “Phase” for “Adjust Signal” in the Screen
menu
properly. (
The color of characters or
the picture is not
appropriate.
c
Select the desired color registration in “Panel Alignment” of
Installation
Image is left on the screen.
(image retention)
c
When high contrast non-moving images are displayed for a long
period of time, there may be some image retention on the
screen. This is only a temporary condition. Turning off the
power for a while will eliminate the retained image.
Symptom
Cause and Remedy
Symptom
Cause and Remedy
On-screen display does not
appear.
c
Set “Status” in the Setup
menu to “On.” (
c
Check if the ON/STANDBY indicator should light in green.
The model name does not
disappear from the screen.
Or else, the demo mode is
displayed continuously.
c
The display mode of the projector may be set at the time of
purchase. Consult with your local dealer or qualified Sony
personnel.
Input terminals do not
appear.
c
Set “Auto Input Search” in the Function
menu to “Off”. (
Symptom
Cause and Remedy
The remote control does
not work.
c
Batteries could be weak. Replace them with new batteries.
(
c
Insert the batteries with the correct polarities. (
c
If there is a fluorescent lamp near the remote control detector, the
projector may work improperly or inadvertently.
c
Confirm the position of the remote control detector on the
projector. (
c
Set “IR Receiver” to “Front & Rear” on the Installation
menu